hi all,
I am trying to load linux on my newly purchased sam9261-ek . For the last two weeks I am unable to do it successfully. T
I can only see Atmel Logo and memory information under that. After this screen nothing comes up.
--------------------------------------------------------
U-Boot 1.1.5 (Sep 13 2007 - 16:02:15)

DRAM: 64 MB
NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0xda ( NAND 256MiB 3,3V 8-bi
t)
NAND: Pagesize: 2048, Blocksize: 128K, OOBsize: 64
256 MiB
DataFlash:AT45DB642
Nb pages: 8192
Page Size: 1056
Size= 8650752 bytes
Logical address: 0xC0000000
Area 0: C0000000 to C0003FFF (RO)
Area 1: C0004000 to C0007FFF
Area 2: C0008000 to C0037FFF (RO)
Area 3: C0038000 to C083FFFF
In: serial
Out: serial
Err: serial
dm9000 i/o: 0x30000000, id: 0x90000a46
MAC: 12:34:56:78:9a:00
operating at 100M full duplex mode
U-Boot>
-----------------------------------------------------------------------
Anyone had similar issues? plz plz help me out ..!!!

here is no1 who cud reply or have solution 4 the same problem..!!!!!!!!!!!
whts the use of this gp. i m highly disappointed with this attitute...!!!!
same thing also happened before in my prev. problem.
plz plz help !!!

I don't know, but the fact that U-Boot is waiting for input, might tell you something.

When I use the batch file from the original distribution on a 9263-ek, U-Boot is delayed by a 3 second timeout, before it boots the kernel.

the same delay apear in my kit also ...but after uploading WInCE files at 0x0 and 0x5000 locations my kit giving this error message...!!!
do any1 havng solution ??????????????????????????????????
its very urgent..!!!! plz

RTFM. The u-boot needs to be configured - the boot command needs to be set up. This is absolutely normal behavior.

so wht i shud do ??? to get demolinux running back on my at91sam9261ek.
thanx 4 help////tooo