hi all,
I am trying to load linux on my newly purchased sam9261-ek . For the last two weeks I am unable to do it successfully. T
I can only see Atmel Logo and memory information under that. After this screen nothing comes up.
--------------------------------------------------------
U-Boot 1.1.5 (Sep 13 2007 - 16:02:15)

DRAM: 64 MB
NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0xda ( NAND 256MiB 3,3V 8-bi
t)
NAND: Pagesize: 2048, Blocksize: 128K, OOBsize: 64
256 MiB
DataFlash:AT45DB642
Nb pages: 8192
Page Size: 1056
Size= 8650752 bytes
Logical address: 0xC0000000
Area 0: C0000000 to C0003FFF (RO)
Area 1: C0004000 to C0007FFF
Area 2: C0008000 to C0037FFF (RO)
Area 3: C0038000 to C083FFFF
In: serial
Out: serial
Err: serial
dm9000 i/o: 0x30000000, id: 0x90000a46
MAC: 12:34:56:78:9a:00
operating at 100M full duplex mode
U-Boot>
-----------------------------------------------------------------------
Anyone had similar issues? plz plz help me out ..!!!
------------------------------------------------------------------------

i think every1 is so much busy with their work that no one is interested to give their few mints to give a reply even..
very dis appointed
_________________

well... you are getting u-boot prompt. Continue with setting up u-boot variables to boot the operating system.

i have already done this ...set all the env. variable....plz tell me how to load linux back to get linux login prombt after uboot delay ...????????????????????????????

set at least the bootcmd environment variable and save variables. Usually you need the kernel command line, too.
To diagnose, what's wrong, give some more information... For example, what have you done, what is in your board flash(es), what environment variables are defined (hint:printenv) etc.

i have solved my problem ....