Hi,
I'm trying to get the gadget ethernet (g_ether module) interface working between a winXP host and my h/w that is VERY similar to an AT91SAM9260EK board.
kernel is 2.6.24.4
I install the module w/ modprobe g_ether
/var/log/messages contains:
Dec 31 17:18:54 at91sam9260dfc user.warn kernel: ether gadget: using random self ethernet address
Dec 31 17:18:54 at91sam9260dfc user.warn kernel: ether gadget: using random host ethernet address
Dec 31 17:18:54 at91sam9260dfc user.info kernel: usb0: Ethernet Gadget, version: May Day 2005
Dec 31 17:18:54 at91sam9260dfc user.info kernel: usb0: using at91_udc, OUT ep2 IN ep1 STATUS ep4
Dec 31 17:18:54 at91sam9260dfc user.info kernel: usb0: MAC b6:ab:51:d4:6d:76
Dec 31 17:18:54 at91sam9260dfc user.info kernel: usb0: HOST MAC 96:97:eb:70:a3:e8
Dec 31 17:18:54 at91sam9260dfc user.info kernel: usb0: RNDIS ready
Dec 31 17:19:23 at91sam9260dfc user.debug kernel: usb0: suspend
Dec 31 17:19:23 at91sam9260dfc user.debug kernel: usb0: resume
Dec 31 17:19:23 at91sam9260dfc user.debug kernel: usb0: suspend
Dec 31 17:19:23 at91sam9260dfc user.debug kernel: usb0: setup complete --> 0, 16/18
Dec 31 17:22:38 at91sam9260dfc user.debug kernel: usb0: qlen 2
Dec 31 17:22:38 at91sam9260dfc user.info kernel: usb0: full speed config #2: 100 mA, Ethernet Gadget, using RNDIS
Dec 31 17:22:38 at91sam9260dfc user.debug kernel: usb0: eth_reset_config
Dec 31 17:22:38 at91sam9260dfc user.debug kernel: usb0: setup complete --> 0, 16/18
Dec 31 17:22:38 at91sam9260dfc user.debug kernel: usb0: qlen 2
Dec 31 17:22:38 at91sam9260dfc user.info kernel: usb0: full speed config #2: 100 mA, Ethernet Gadget, using RNDIS
Dec 31 17:22:43 at91sam9260dfc user.debug kernel: usb0: suspend

XP begins installing the driver linux.inf but then stops w/ This device cannot start (Code 10)
Can anyone help me with this?
Regards,
Joe