Atmel website | ARM Community | AVR freaks | Technical Support
Banner
 FAQ •  Search •  Register •  Login 

View unanswered posts | View active topics


Board index » OPERATING SYSTEM » Linux

All times are UTC + 1 hour [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
fcx123123
 Post subject: How can I mask usb host 2 in at91rm9200 PQFP208?
PostPosted: Thu Jul 31, 2008 12:04 pm 
Offline

Joined: Thu Jul 31, 2008 5:11 am
Posts: 2
When Linux starting, usb driver always print the message below:
usb 1-2: new low speed USB device using at91rm9200-ohci and address 2
usb 1-2: device descriptor read/64, error -110
usb 1-2: device descriptor read/64, error -110
usb 1-2: new low speed USB device using at91rm9200-ohci and address 3
......
In some boards, the likely messages is printed per serveral seconds.
I don't know the resan. Perheps because usb host 2 is not lined out in at91rm9200 PQFP208 packaged?

thanks a lot. :)
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » OPERATING SYSTEM » Linux

All times are UTC + 1 hour [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: