with at91sam9261ek , wince 5 bsp, pb 5 no patch,
when i use the sd card , i got these:
SD/MMC card insertion detected
SDMMC:InitDisk with pDisk 0x3b7fa0
SDCard Initialisation Successful
Master Clock is 89915904 Hz
ConfigClockFromRegistry : Computed Clock = 4995328 Hz
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
ReadData : retry 6
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
ReadData : retry 7
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
ReadData : retry 8
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
ReadData : retry 9
WaitForSingleObject == WAIT_TIMEOUT (808)
StatusMask = 0x8
status 0x8085
WaitForStatus error status = 0x8085
read multiple Prb
ReadData : retry 10
SDMMC:DoDiskIO - ReadData failed
------------------------------------------------------------------------
i do not know what to do ?who can help me with this?
i am new with wince and sd works well in linux!
with bsp ,i just choose the
Third Party->Bsps->at91sam9261ek->storage driver->sd driver
help me?!!!!!

Seems the problem occurs on Multiple Read command (CMD18). Are you sure the card you used in test support it? or is it a High Capacity card?

you mean the card i use did not support the "cmd18"?
i am not sure about this, but i can use it on linux!
and its capacity is 512M!

can i just remove the "cmd18" ?
thank you very very much!~

i got this resolved!
check the pins if you got the same pro~