Dear all,
I have just made a change in Adeneo's serial driver and run build in debug mode (configuration manager--->debug).

I have find out that new .obj has been produced in the retail folder

C:\WINCE600\PLATFORM\COMMON\SRC\SOC\ATMEL\COMMON\DRIVERS\Serial\obj\ARMV4I\retail

while I was expecting it to be generated in debug folder

C:\WINCE600\PLATFORM\COMMON\SRC\SOC\ATMEL\COMMON\DRIVERS\Serial\obj\ARMV4I\debug

My question: is there anything I shall do to have drivers in debug mode, beside choosing "debug" from platform builder?

Any change in make file?


Thanks
Regards

Hi adamax,

Normally it works well.
Please ensure to build the driver after changing the build type.

HTH