Image Sensor (ISI) IRQ?

yanker-ssnh · **Posted:** Fri Jan 18, 2008 3:30 pm

I want to use Interrupts on ISI controller, but I don`t know ISI IRQ? What is it?

Adeneo · **Posted:** Mon Jan 21, 2008 5:03 pm

Hi,

You can find this information in the SAM9263 datasheet.
In chapiter 10, the IRQ coresponding to the Peripheral ID.
In your case, for ISI is IRQ 25.

Adeneo

yanker-ssnh · **Posted:** Mon Jan 21, 2008 6:05 pm

I find this ID. I use this ID in function KernelIoControl and Sysintr in InterruptInitialize. But I don`t view interrupt on ISI. Does evalution BSP work with ISI interrupt? If yes, can You post me example use this controller ISI.

yanker-ssnh · **Posted:** Tue Jan 22, 2008 8:39 pm

Does Evalution BSP support image Sensor Interface?

Adeneo · **Posted:** Wed Jan 23, 2008 5:01 pm

The BSP does not contain ISI driver.
You must develop the driver by your own.

To use ISI interrupt, you need to request a sysintr by using KernelIoControl(HAL_REQUEST_SYSINTR, ....).
Then use the InterruptInitialize api to link the sysintr with a event.

yanker-ssnh · **Posted:** Thu Jan 24, 2008 10:24 am

I do KernelIoControl and InterruptInitialize. But then I see AIC->IECR for ISI (25), there is no set bit. Then I set this bit (eneble AIC to interrupt by ISI) and interrupt from ISI is appears, Windows is stopped and down.

Image Sensor (ISI) IRQ?

Who is online