Dear Friends,

Moving ahead I got stuck up at Touchscreen. I got output on LCD for calibration, "Press and briefly hold stylus on the centre..." but when I press at the centre using stylus nothing happens further. On the Serial Terminal I am getting following error message:
"ERROR: d:\wince500\platform\at91sam9261ek\src\drivers\touchscreen\dll\ads7843sp:
MSIM: IM_ReadRegistry read KB 5"

Importantly I have my wince500 installed in c: drive and not under D: drive. Is anything wrong with the Installation?

Complete Booting Log at http://pastebin.ca/1050097

Any suggestions are highly appreciated.

Thanks,
Ankur.

Have a Good Day.