Hello,

I am new to this area, so far I write applications for CE devices but never messed with the OS. So now for the real thing. I have a G20 eval board at hand, installed the USB driver and SAM-BA. Compiled the Atmel demo and ran it. So far so good. Now I went into the Adeneo BSP and try to follow the instructions and this is where I get screwed.

So I want to load a wince boot loader, according to the description I have to load it to the DataFlash. Now the problem. If I run the EK with J33 closed (enabled DataFlash) then some Atmel application seems to run blinking the led's and I can not get a USB connection. If I open this jumper, I can connect USB, but I do not get access to the DataFlash as it is not enabled. I verified this with J34, which is the jumper for the nandflash, if it is open, no nand, if it is closed then there it is.

How do I overcome this, means what do I have to do to boot the EK with USB and DataFlash?

Found the solution to this one, had to use CS1, now I can initialize but not write to it. Means I can execute send boot file and send file, but if I compare the memory against the sent file it comes back with no match. Any idea?