Hi
In my application only the USART0 port is accessible . And I'm looking for a solution to make an update of my program via this port .
Is there a solution ?

Thanks a lot

oups i 've just seen that i ' ve no specify my µC , i use sam7s256

thanks for your reply

nic

Hi

See http://www.utasker.com/docs/uTasker/uTa ... Loader.PDF

This is an SREC loader via UART. It runs on the SAM7X so should also be suitable for the SAM7S.

Note that the in-build loader also allows programming over DBGU using SAMBA. This requires the Boot from FLASH NV bit to be erased so that the boot loader starts.

Regards

Mark