Hi! Every body.
I am beginner of ARM processor and programming development.
I used following tool to program and download to evaluation board via J-link kit by 2 way from j-flash ARM V4.04a and µVision3 V3.80, two ways are ok, the blinking led operate. But when I unplug USB ( power supply and debug communication) then plug again, blinking led is off. It seem the program loss or not running.
Please help me to solve this problem,
blinking led project follow the attachment file.
Thank you in advances !

IDE-Version:
µVision3 V3.80
Copyright (c) Keil Elektronik GmbH / Keil Software, Inc. 1995 - 2009
Tool Version Numbers:
Toolchain: RealView MDK-ARM Version: 3.50
Toolchain Path: BIN40\
C Compiler: Armcc.Exe V4.0.0.524
Assembler: Armasm.Exe V4.0.0.524
Linker/Locator: ArmLink.Exe V4.0.0.524
Librarian: ArmAr.Exe V4.0.0.524
Hex Converter: FromElf.Exe V4.0.0.524
CPU DLL: SARM.DLL V3.50
Dialog DLL: DARMATS.DLL V1.15
Target DLL: Segger\JLTAgdi.dll V???
Dialog DLL: TARMATS.DLL V1.13

Hi!
May be you write your program in flash and boot from ROM? Or otherwise.
I'm using SAM-BA software to download bin-files and there's a script option 'Boot from flash'. It allows program to be run just after software reset or usb-connect

Thanks for your answer!
I set configuration target to download as the attachment file bellow.
Please see attachment file to help me!
Best Regards.

hi!
I also used H-converter v2.0 of H-jtag to convert hex file to bin file and download by sam-prog 2.4 and j-flash 4.04a but nothing change.
anyone help me, please!