Need Bootloader Code for AT91SAM7x512

mahadev · **Joined:** Sun Jul 25, 2010 2:43 pm **Posts:** 2

Hello,

I am Mahadev, Working on AT91SAM7x512 Microcontroller. My microcontroller doesn't have the preloaded bootloader. I need bootload code or .bin or .hex file.

So please help me with the code.

Thanks in Advance.

Regards,
Mahadev

mjbcswitzerland · **Posted:** Sun Jul 25, 2010 3:57 pm

Hi Mahadev

The boot loader should be installed in all devices and can not be deleted (as far as I know). Try performing a chip erase using the ERASE pin - then the device must start in the boot loader and can programmed either via USART0 or USB.

Regards

Mark

www.uTasker.com

mahadev · **Joined:** Sun Jul 25, 2010 2:43 pm **Posts:** 2

Hello...

Previously I was using microcontroller with preloaded bootloader but due to unavailability of those, I am using microcontroller without preloaded bootloader.

So it will be helpfull if you could suggest any readily available solution.

Thanks & Regards,
Mahadev

mjbcswitzerland · **Posted:** Tue Jul 27, 2010 7:39 pm

Hi Mahadev

Assuming you can load code with JTAG there is a SREC boot loader and an Ethernet boot loader in the uTasker project:

http://www.utasker.com

Regards

Mark

Need Bootloader Code for AT91SAM7x512

Who is online