hello

I'm trying to do a module with the AT91SAM7X chip.
I was wondering how the PLL filter is related to any setup in the code (DIV MUL).
And how the speadsheet from ATMEL regarding the PLL filter is used.
And is the Fout the frequency, that the AT91SAM7X chip will function at.
Or am I all wrong

Best Regards

Jacob

post has been showed 54 times so far, and no response...
Is it really possible, that the PLL area has been designed, and then forgotten for further support from everyone at Atmel.

Sure it's easy to look at the AT91SAM7X-EK board and conclude, that they made THE best solution for ANY SAM7X board...

As an engineer, it would be nice to know how it works in detail (the spreadsheet), instead of copying, and be ok with that.
And I still guess, that the PLL settings also should be incorporated into the code in the MUL and DIV registers...

So come on... PLZ try to make a response here...
I'm going to do a project without any colleagues with knowledge of the ARM world....

Regards

Jacob