Hi all,
I am using a AT91SAM7S128 board, and trying to configure USB using the demo code. I have ported the IAR code to ADS and trying to build and download.
I am able to download but, the USB when connected to PC, fails enumeration, always vid and PID are shown as 0000.

I am not able to debug the due to some unavailability of ICE, and there is no UART connections on the board to collect debug strings.

I have another AT91SAM7SE32 board, which when loaded with ported demo code, works fine.

Has any one of you have faced the similar issues?

Regards
Pradeep