I'm trying to put together a layout and I need to put a JTAG connector on the board, does anyone know where I can find the specification for a 14 pin JTAG connector?

You really should use the 20 pin header since it replaces the older 14 pin version. See attached images though for information.

I am not sure this posting of the images is working. If still not working later, will try putting it up in another format.

Hi smcallis182,
you can also take a look at the jtag connector which is located on the atmel evaluation board(s). The schematics can be found in the internet or or on the Atmel ARM CD (mentioned in this forum).


Best regards,
Edi