Hi there.

I'm a newby in the ARM-controllers (a profession in ATMEGA) , so i do my first steps with this controller.

Does anyone have a include-file (at91sam7a3.h) for the controller?
Best would by for the IAR compiler. For this compiler i need the definition file AT91SAM7A3.i79.

Is it available . I have downloaded the last version (4.20a), but in this there is only the AT91SAMS64 supported .

What can i do?

I need to write a little Hello World program (LED-blink....) to show me: it runs.



Please excuse my bad english, i'm german......

Hey,

We are currently developing a board based on that MCU and thus are writing the libraries ourselves for most of the modules. It isn't really that hard. If you tell me which modules you need the libraries for I can pass down the files as they are written. Also check out the resources area of this forum for a zip of Atmel libraries. With a bit of modification they are a good starting point.

Attached are some sample files for the CAN module.

Alain Rodriguez, CDH TL
UCF Funsat Design Team