Atmel website | ARM Community | AVR freaks | Technical Support
Banner
 FAQ •  Search •  Register •  Login 

View unanswered posts | View active topics


Board index » PRODUCTS » SAM3 Cortex-M3 MCU

All times are UTC + 1 hour [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
raviraj2018
 Post subject: USB Bulk read request
PostPosted: Mon May 07, 2012 7:29 pm 
Offline

Joined: Mon May 07, 2012 5:50 pm
Posts: 2
Hi,

I am using SAM3U evaluation board. I have configured a bulk in and bulk out ep. From the host side if I send a control request to the control end point usb firmware is working fine. However as soon as I try to do a bulk read / out , there is no response from USB device. I am using hyper terminal for checking the debug messages. It seems there is no output from the UDP_Isr as in case of control requests.

can any one provide an example to do a bulk read and write USB FW ??
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » PRODUCTS » SAM3 Cortex-M3 MCU

All times are UTC + 1 hour [ DST ]

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: