Home 
Forum
Forum
| Welcome to AT91SAM Community Forum http://www.at91.com/samphpbb/ |
|
| SAM-BA freezes http://www.at91.com/samphpbb/viewtopic.php?f=26&t=19384 |
Page 1 of 1 |
| Author: | aleksazr [ Wed Jul 14, 2010 5:07 pm ] |
| Post subject: | SAM-BA freezes |
I've made my first AT91SAM9260 board. It is based on Atmel's '9260-EK, but has no NAND flash (at least). In file "CustomApplet.txt" (from SAM-BA) I read that I have to change some scripts to make it work with my custom board. Before I do that, is SAM-BA able to connect with my board, at all? I power-on my board then start SAM-BA and select original "at91sam9260-ek" and nothing happens - i.e. the prog freezes. When I first started this, I've mistakenly connected RX & TX the wrong way to the MAX3232 and SAM-BA said "No valid processor ID found". I've connected RX & TX correctly now and SAM-BA just sits, forever. However, before that, I should be sure that my oscillators are working. Well, they both work (32kHz and 20MHz) but the voltage swing is very low - between 0 and 0.5 V, is that OK? The frequency itself is OK. |
|
| Author: | aleksazr [ Thu Jul 15, 2010 10:52 am ] |
| Post subject: | Re: SAM-BA freezes |
I've started HyperTerminal and I can see "RomBOOT" displayed. That means my osc is working and that I *must* change some scripts in order to get *anything* from sam-ba, right? |
|
| Author: | aleksazr [ Thu Jul 15, 2010 11:46 am ] |
| Post subject: | Re: SAM-BA freezes |
Also, after typing V# I get this: v1.7 Jul 13 2007 14:54:32 |
|
| Author: | aleksazr [ Sat Jul 17, 2010 10:19 pm ] |
| Post subject: | Re: SAM-BA freezes |
Upgrading to SAM-BA 2.10 solved the problem. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|
