Welcome to AT91SAM Community Forum :: View topic - How to Reboot G20 after SAM-BA flashing ?

Welcome to AT91SAM Community Forum http://www.at91.com/samphpbb/

How to Reboot G20 after SAM-BA flashing ? http://www.at91.com/samphpbb/viewtopic.php?f=26&t=19421	Page 1 of 1

Author:	ghofman [ Tue Jul 27, 2010 7:44 pm ]
Post subject:	How to Reboot G20 after SAM-BA flashing ?
Dear AT91 users, We have a G20 board that right now we are programming by very inelegantly wrapping a simple SAM-BA using .tcl script from a C# windows interface. We use JTAG. The tcl uses send_file calls to program at91bootstrap, u-boot and a kernel to NAND. Then a reboot trigger u-boot to load a root file system (60 MB) over ethernet to RAM, then burns it also to NAND flash, completing the programming. My question: can I trigger a reboot of the ARM after completing the .tcl script ? The SAM-BA manual shows a Tcl_GO and a go command but naive tries like 'go 0x0' doesnt work. Since this is prior to a re-map I would expected to be able to restart the chip by executing at address 0x0. Thanks Gertjan

Page 1 of 1	All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/