Hi all,

I'm facing a problem using SAM-BA on an Atmel AT91SAM9260-EK board.

Maybe I messed up writing some wrong image in Dataflash or NAND.

Now my problem is: when trying to connect using SAM-BA, it always replies "No
valid processor ID found".

SETTINGS:

Board: Atmel AT91SAM9260-EK
SAM-BA version: 2.7
Jumper J2: closed
Jumper J3: closed
Jumper J6: closed
Jumper J7 (BMS): closed
Jumper J9: 2-3
Jumper J10: 2-3
Jumper J12: closed
Jumper J15: closed


I already tried to :

1. press the BP4 button together with the reset button before running SAM-BA, but it didn't work (I tried every combination!)

2. connect pin 11 and pin 35 of J24 and then running SAM-BA

3. flash the recovery image on an SD and then power-up the board

4. use SAM-BA with the USB cable (instead of the serial) using "\usb\ARM0" but it says "connection unknown"

Any help is very welcome.

Many thanks,

Claudio

P.S. If someone has a Lauterbach T32 script for this board, it would be really appreciated!

I think you need J7(BMS) to be open. That is the proper setting to get the on chip boot code to run.

Yes, that was the problem.

Thank you.