Hello,

i try to get ANDROID on my AT91SAM9M10-G45-EK board NAND-Flash.
I used the manual from the Andoid4Sam Webside

http://www.at91.com/android4sam/bin/vie ... moArchives

What i have done:
> Downloaded Pre-Build-Image for Android for SAM9M10 MCU for NAND-Flash
> Connect Board with my PC (XP)
> Started the at91sam9m10.bat

After this a notepad pops up

-I- Waiting ...
-I- TCL platform : Windows NT
-I- SAM-BA 2.9 on : windows
-I- Retrieved arguments from command line :
-I- argv 0 : \usb\ARM0
-I- argv 1 : at91sam9m10-g45-ek
-I- argv 2 : at91sam9m10.tcl
-E- Board at91sam9m10-g45-ek not found
-E- Supported boards : at91sam7a3-ek at91sam9263-ek at91sam7s64-ek at91sam7sl32-stk at91sam7l64-ek at91sam7l128-ek no_board at91sam9m10-ek at91sam7xc256-ek at91sam7sl16-stk at91sam7s256-ek at91sam9260-ek at91sam7xc512-ek at91sam7s512-ek at91sam9xe256-ek at91sam7x256-ek at91sam3u4-ek at91sam7se32-ek at91sam7se256-ek at91cap9-dk-mem33 at91sam7xc128-ek at91sam7s128-ek at91cap9-stk at91sam9xe512-ek at91sam7x512-ek at91sam7se512-ek at91sam7s32-ek at91cap9-dk-mem18 at91sam7s321-ek at91sam9xe128-ek at91sam9rl64-ek at91sam9g45-ek at91sam9g10-ek at91sam9g20-ek at91sam9261-ek at91sam7x128-ek at91sam7sl64-stk


You could see that my board is detected but not under the supported board list.
Is there a supported Android-version for my board?

So what can I do??

Thanks

Stefan

Try using a newer SAM-BA 2.11. If that does not work, edit the .bat file to give at91sam9m10-ek as argument. the at91sam9m10-ek-g45-ek board is after all a at91sam9m10-ek board.

It´s better with Samba 2.11 but there is a new Problem you can see in the picture .

After i quit the Error, the logfile poped up:

-I- Waiting ...
-I- TCL platform : Windows NT
-I- SAM-BA 2.11 on : windows
-I- Retrieved arguments from command line :
-I- argv 0 : \usb\ARM0
-I- argv 1 : at91sam9m10-g45-ek
-I- argv 2 : at91sam9m10.tcl
0
\USBserial\COM7

I installed Samba again but all without any success.


Thank you again

Dear StefanKE,

I also encounter same problem with you for "Error h_handle return zero". Have you overcome this problem? Possible to share with me? Thanks.

You could reach me with rickysiah@hotmail.com