I close ERASE pin and plug in usb cable for 10secs. THen Unplug cable and plug back in.

The AT91 Serial to USB converter is shown in the Com & LPT section of the Device manager as COM5.

I start sam-ba v2.9. I get the connect box where I select COM5 and at91sam7x256-ek board. Hit connect. THe connect box goes away and nothing else happens. I do not get the sam-ba interface to come up. If I look in the task manager/processes I see a sam-ba process running.

I have tried this on 3 XP and 2 Vista machines with no luck and with two different sam7x256-ek boards.

What am I possible doing wrong?