Today I would like to introduce Atmel ATSAM3U Starter kit to you to let you start to know the ATSAM3U family and develop your project based on ATSAM3U processors. Here we go:
ATMEL ATSAM3U Starter Kit is the low cost development kit for ATSAM3U (96MHz, the ARM Cortex-M3 processor built-in High Speed USB controller),
including the ATSAM3U evaluation board(AT3U) and Emlink for ARM(EAH1) JTAG adapter, so the developers can easy start to learn and test all the relevant applications on it, or evaluate your new project design through this entire system.
The ATMEL ATSAM3U ARM-CM3 Board: The ATSAM3U ARM-CM3 Board is an ARM embedded evaluation board produced by Embest, integrate the ATMEL Cortex-M3 core-based processor ATSAM3U4E, operating at 96 MHz frequency. The board features USB, I2C, MCI interface, TFT-LCD, USART interface, 96 I/O port, EBI support SRAM/NOR/NAND memory, etc. Plenty of software examples, which can be used in Keil MDK environment, are accompanied in CDROM.
* Internal 256KB Flash, 48KB SRAM
* 240x320 TFT LCD
* Source code of example program
The JTAG Adapter - Emlink for ARM: Emlink for ARM is a new-generation high-speed real time JTAG adapter, debugs the ARM Cortex-M3 processors through Keil Realview MDK and IAR EWARM. Emlink connects the JTAG interface from target board (ARM processors) to PC USB port, supports source level debugging and Flash programming.
* Downloading and debugging speed up to 250KB/s
* Single-step execution supported.
* Integrates seamlessly into IAR Embedded Workbench and Keil RealView MDK
For more details about ATMEL ATSAM3U Starter Kit, please refer to:
http://www.embedinfo.com/en/class.asp?Page=3.
Forum
