AT91SAM7X256 development board(china)

Each EBDSAM7X256 Engineering Development Board comes with the following:

One AT91SAM7X256-AU ( Free!!!)
One EBDSAM7X256 Development Borad
One A/B-type USB cable
One crossed serial RS232 cable
One RJ45 crossed Ethernet cable
One Switching Power supply (Output:DC +9V/2A)
One Parallel cable
One JTAG board
One CD-ROM ,
includingalldocumentation,schematics,software,development
tools,and related information.

Hardware:
256Kbytes Flash
64Kbytes SRAM
2MB Dataflash(AT45DB021B)
8KB EEPROM(AT24C08A)
One DBGU serial communciation port
One JTAG/ICE debug interface connector withe 20pins
One RS485 serial communicatuon port
Two RS232 serial communication port with RTS/CTS
Five-channel serial CAN-Bus communication port
One USB 2.0 High-speed Device port
One 10M/100M Ethernet interface with network
transformer and Leds
Four key-press for user
One key-press for resetting the MCU and other
devices
I/O Expansion Connector
+9V Power Connector
One SD card slot(other side of this board)

Software
1)all kinds of codes(ADS1.2 and IAR for ARM)
2)uC/OS-II*+Lwip
3)FreeRTOS+uIP
4)FreeRTOS+lwip

uC/OS-II is a commercial software,more information please visit http://www.ucos-ii.com/ ,the code run under this board only for study!!

Its looking good. Do you have a website with more info and price?

the price of this board is 200USD,not inclued ship-cost.
Website:
http://www.embedall.com
http://www.szembed.com

at91sam9261 development board( linux and wince.net) is coming

at91sam9261-dk
Hardware:
1.AT91SAM9261-CJ(A)
2.64MB SDRAM
3.64MB Nand flash(
4.2MB dataflash(U-boot)
5.Power solt:input:+5V/2A,DC
6.SD card slot: SPI mode
7.CF card slot:support FAT filesystem
8.10M/100M Ethernet(RJ45 interface)
9.USB host port*2
10.USB Device port*1
11.CAN-Bus interface:SPI mode ,MCP2510.
12.Audio input/output, mic input
13.UARTs(3-wire and 5-wire)
14.DBGU
15.LCD/Touchscreen:LQ035Q7DH01(320*240) or PD064VT5(640*480)
16.jtag for AT91SAM9261 and CPLD(ALTERA)
17.idle battery
18.LEDs*4 and Keypad*4
19.I/O Expansion Connector

Is there an LCD interface to the board?

yes,there is a LCD connetor on this board.