Does anyone know where I can obtain a connector for the EBI footprint on the 9260-EK dev board? It is an FCI connector P/N 10032206-0100AA, but FCI says the connector is out of production. If a connector is unavailable, is there anyway to tap onto the EBI bus?

I just wanted to ask the almost same question.

Does anyone know where to get the connector?

regards
Thomas Pototschnig

Hi,

Please have a look to this application note:

http://www.atmel.com/dyn/general/tech_doc.asp?doc_id=11114

Regards,
bdenis

hello,
tha application note i already known.
the problem is that atmel selected a connector which is not easy to buy in europe.

regards
gerhard

I had *some* luck contacting the following distributor (mr Farshee). Not that I got the parts yet. Please post if you actually get what you need, so I know for the future:



Amphenol InterCon Systems, Inc.

2800 Commerce Drive

Harrisburg, PA 17110

Tel 717/540-5660



Our regional manager, immediate supervisor and engineering data source is Glen Buschbaum in San Jose 408/323-1603.


Thank you for your interest in our products. Should you have any questions please contact my office or Glen Buschbaum.


Louis Farshee

APEX TECHNOLOGIES

Manufacturer’s Representative for

Amphenol InterCon Systems, Inc.

Tel 503/644-8399; fax 503/644-9084

Cellular 503/522-8844

Hi,

We need the same connector for AT91SAM9260 could you please suggest where to get the connectors.