Hi,

I am using an at91rm9200dk board running u-boot and would need some help to add some features like:
- use serial port 0 (and not debug) for console,
- access the A/D that is onboard,
- add my own functions.

I have also added an FPGA connected to the processor and I saw that u-boot seems to 'support' some FPGA... I saw that some CONFIG_ defines existed but can't find much information on what can be done.
Any clue?

Thanks in advance.

Ron

Hi Ron,

the uboot developper manual should give you this information.

Bye

Hi,

thanks for the post.
Are you talking about the DULG manual?
If not, where can I find this manual?
If yes, I can't find this information...

The information I found on FPGA functions makes it clear that I will have to write my own code for that (and it should be OK).

I did manage to implement my own functions but I still find it hard to add a driver for the on-board A/D or change the console serial port.

Any help on those 2 last points would be apreciated.

Regards.

Ron