Hi,

I have a SAM7 EX256 Board , OLIMEX.

i get the follwing exception message when ever i try to debug the program (In the EWARM):

" Failed to Initialize the RDI Driver (WinRDI openagent)

Check the RDI driver configuration,cables,power etc.

H-Jtag Server not ready.Please make sure that the hardware is properly connected and powered up.

Session Aborted !! "

My HOST OS: WinXP .
JTAG : ARM- JTAG cable by OLIMEX


i had started the HJTAG before using the EWARM Application ..

But it never connected it always said unable to detect target.

After i accidentally shorted the erase jumper pins, i am in a desperate state to push some code into the board ... the LED OLIMEX logo which was glowing earlier has also gone !!

I tried installed the SAM- BA from Atmel and tried to burn to the flash some code using the JTAG, then Serial cable ,( for some reason i never got the USB option) but in vain ....

I am now staring at a black box i donno what to do ...

Please help me ...

If you have any queries or Logs that you want you can very well ask me to that .. i shall try it out ...

Any guidance suggestion will be higly appreciated...

rgds
som[/b]