Hi,

Could any one help me how to adjust the jumpers.

I am Using Atmel CAP-DK board (AT91CAP9A-DK) I am unable to access the board through the SAM-BA Jtag or USB . It is showing an error message. I installed all the updated versions of the softwares but I couldn't resolve the probelm.

So, please help me out how to adjust the jumpers to up the board .

Are there any default settings.

Please mention me where to change .

I hope an early reply.

Thanks,
Srinath.

Hello Srinath,

This question must be sent to capsupport@atmel.com.
They will be able to give you answer.