Atmel website | ARM Community | AVR freaks | Technical Support
Banner
 FAQ •  Search •  Register •  Login 

View unanswered posts | View active topics


Board index » ECOSYSTEM » Evaluation and Development Boards

All times are UTC + 1 hour [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
sanjana
 Post subject: What baud rate should be set for COM 0?
PostPosted: Sat Nov 22, 2008 9:47 am 
Offline

Joined: Sat Nov 22, 2008 8:10 am
Posts: 3
I have got AT91SAM9263-EK.I m able to work with DEBUG Port with 115200 baud rate.Hovewer not able to see anything on COM 0 port.

1)what baud rate must be set for COM 0 port?
2)Any hardware settings are required?
3)Can we work with COM 0 port when Debug port is connected? :roll:
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » ECOSYSTEM » Evaluation and Development Boards

All times are UTC + 1 hour [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: