I have an AT91SAM9RL-EK, but so far, I have been unable to load any of the example projects on the board. I have loaded Linux4SAM / Angstrom on the board, so I know that the board is functioning.

I have been performing the following steps. I don't know where I'm going wrong.

1) Remove jumpers J12 and J13
2) Boot the Device and connect SAM-BA to \usb\ARM0
3) Enable jumpers J12 and J13
4) Click on the NandFlash tab in SAM-BA
5) Run the "Send Boot File" script with the provided "getting-started-project-at91sam9rl-ek-at91sam9rl64-sdram.bin" file
6) Unplug USB cable
7) Reboot Board

However, after all of these steps, the board fails to do anything other than boot to SAM-BA mode. Please help!