Hello,

Im trieing to access my Olimex Board (SAM9-L9260) directly via JTAG (ARM_USB_OCD) without ISP. When i try to connect, i use Crosswork for Arm 1.7, it says "Cannot identify target". Im not sure wheather i got all the config right. Does JTAGSEL has to be low or high? Are there some other Pins to be configured? Access via DTXD, DRXD works fine.

THX
Romil

Section 12.5.2 indicates that JTAGSEL should be low for embedded ICE mode and high for JTAG mode. However, when I pull it high on the eval board, my tool set (IAR Embedded Workbench with J-Link) complains that it can't read RTCK.

If I don't make any changes to the eval board, I can load code into SRAM and SDRAM, but Embedded Workbench freezes up when I try to program Flash, even when using one of the example projects.

Hopefully that helps.