Atmel website | ARM Community | AVR freaks | Technical Support
Banner
 FAQ •  Search •  Register •  Login 

View unanswered posts | View active topics


Board index » ECOSYSTEM » Evaluation and Development Boards

All times are UTC + 1 hour [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
sujendra
 Post subject: Running USART hardware handshaking through bootstrap
PostPosted: Sat Feb 14, 2009 10:47 am 
Offline

Joined: Wed Dec 24, 2008 2:21 pm
Posts: 3
Hi,
I am using At91SAM9263-EK rev- B.
I am able to run the USART hardware handshaking application by directly executing it
through the SAM-BA. but if I embed same application with AT91Bootstrap1.11 for dataflash card, I am not able to connect to serial port.

Tip:: I am able to run the LCD application by the same way i.e. embeding LCD application with AT91Bootstrap1.11.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » ECOSYSTEM » Evaluation and Development Boards

All times are UTC + 1 hour [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: