Hi all

I was wondering if anyone is using the AT91SAM9260EK with VxWorks 6.6 or newer? I have acquired the -9260 and D/L'ed VxWorks BSP for the board, but I can not get it to work with the default boot loader.

This is what I do:
* Set up a closed network with my PC and the AT91SAM9260EK
* Set up host IP address, FTP server, serial terminal etc. in acc. with bootrom specifications
* Download bootrom.bin using SAM-BA v2.7 to address 0x23F00000 (SDRAM)
* Execute bootrom.bin

This is what I see:
* The boot loader executes without incident. I see the boot loader's prompt etc. fine on serial terminal
* Sometimes, the boot loader logs in on the FTP server and starts to retrieve the image file. Sometimes it seems to hang before getting this far
* At some point during retrieval the boot loader hangs
* VERY rarely, the image is loaded and executed.
* Using Wireshart I can see a lot of lines with "FTP-DATA [TCP Retransmission] FTP Data: 1460 bytes" and "FTP [TCP Retransmission] Response: 451 Error 10054 in network on send"

Has anyone encountered similar problems? Or does anyone have an idea as to what may be worng?

Best,
Troels