Hi,

I have built bootstrap, u-boot, linux kernel and buildroot as per directions on the linux4sam website.
I am developing on Xubuntu Linux and would like to know the tools I can use for flashing the board
as well as debugging the execution.

I have a SAM ICE from Segger which seems to be for Windows.
Is it possible to use this from Linux?


Regards,
Anup

Yes you can use the SAM-ICE under Linux. Concerning board programming you can use SAMBA GUI for Linux:
http://www.at91.com//Tool/Controleurs/cVisualisation.php?idVisualisation=372

Hi gpouly,

For programming the board:
SAM-BA linux crashes with a file flush error on specifying the ttyUSB device and the board number.

For board development:
I believe that the windows installation requires a critical DLL from the Jlink software provided by Segger.
How is this achieved in Linux?

Kindly elaborate on the linux setup.

Regards,
Anup

the simplest way is have both Os linux for compiling and windows to use Sam-ba
i know is a ***** but so its life jajjaja .
the other r way wold be use virtual machin in windows to run the lynux and compile, haven´t test it.