Hi all,

I have made a 9260 based board. It works with the ICE interface.
But, I am facing some issues while making it standalone.

BMS = 1
OSCSEL = 1
When i power up the board i have to see "ROM Boot >" printed on the DBUG UART.
I have no firmware loaded in any of my spi flash devices.
Also the clocks(sdram) by default should be 48Mhz. But when i measure the clocks it reports 18.432 Mhz.
My inputs clocks are 18.432Mhz and 32khz respectively.

Can somebody suggest ? Am i missing any important pull-ups/pull-downs ?