|
Hi atmel
I am using at91sam9g35ek development board.First i tried the angstrom demo available in linux4sam website.Everything was fine.
I tried kernel 2.6.39 with corresponding patches and cross-compiled it by buildroot 2011.05 toolchain (buildroot also recommended by linux4sam). When i am running my own kernel in evaluation kit, i am facing a problem with EHCI hub.It is not accepting any usb device.It is returning error like
"May be USB Cable is bad?, unable to enumerate device on port"
But OHCI controller working very fine.Any ideas?
Which one is the problem? Am i missing anything?
Regards
Vignesh Rajendran
Embedded Linux Engineer
Vaaraahi Embedded
|
Forum
