SAM3U SSC as I2S for Codec problem

IBE · **Joined:** Fri Dec 23, 2011 2:38 pm **Posts:** 10

Hi,

I have some problems configuring the SSC as a full duplex SSC for a Codec.
Figure 31-18. Codec Application Block Diagram (page 562) in the datasheet shows connection with a Codec with all the Transmitter pins connected (TK, TF, TD), and then RD for receiving data.
But I can't find how I can configure the Receiver for the ADC data to get the transmitter's frame signal for the receiver. The bit-clock TK can be routed to RK, but not TF to RF.
Any ideas?

Thanks,
Chris

Technosvitman · **Joined:** Fri Jun 01, 2012 8:53 am **Posts:** 11

Hi,

it depend on your codec. Send your codec reference if you want to be helped.

Best regards.

SAM3U SSC as I2S for Codec problem

Who is online