Hi all,
it is maybe a silly question, but on which kind of output I can connect a LED just to try to switch it on or off?
The LED on the board is connected to a MCDA socket (Multimedia Card Slot Data) but on the external connector there is no output like that. Any Output can work if I configure it correctly or not?
Thank you in advance for your advice.
Regards,
Arnaud

hello,
did you take a look at the schematic?
according to it there are 2 led's already at the board:
green LED STAT (connected to PA6)
yellow LED PWR_LED (connected to PA9)

regards
gerhard

Yes Yes, I know, but I would like to connect another one on the external connector. Does the Output has to be specific?
Regards,
Arnaud