AT91SAM9260-EK SAM-BA Recovery

Reference documentation

AT91SAM9260-EK SAM-BA Recovery application note.

You also have a brief AT91SAM9260-EK Bootstrap Recovery Procedure chapter in the AT91Bootstrap application note.

In brief

On AT91SAM9260-EK platform, there is no way to disconnect the on board DataFlash. If valid code is present in the first DataFlash page the chip will execute it before connecting to SAM-BA. AT91Bootstrap features a recovery method :
An erase of the first dataflash page is performed if button BP4 on the board is pressed after reset.

To erase the first dataflash page :

  • Push the button BP4
  • Push the reset button while BP4 is pressed
  • The following message is displayed on the serial console :
INFO : Low Level Init : OK
Starting main ...
Testing BP4
BP4 is pressed. Erasing First Page of SPI data Flash CS1
Please reboot....
r1 - 19 Sep 2007 - 12:45:09 - NicolasFerre
 
Linux & Open Source related information for AT91 Smart ARM Microcontrollers

Copyright © by the contributing authors. All material on this collaboration platform is the property of the contributing authors.

Linux® is the registered trademark of Linus Torvalds in the U.S. and other countries.

Atmel® and others, are registered trademarks or trademarks of Atmel Corporation or its subsidiaries. This site is powered by the TWiki collaboration platform

ARM® and others are registered trademarks or trademarks of ARM Ltd. Other terms and product names may be trademarks of others.

Ideas, requests, contributions ? Connect to LinksToCommunities page.

Syndicate this siteRSS ATOM