SAM7-P256 boot problem

Microchip in-system programming solution: SAM-BA

Moderators: nferre, fab

scuzzy
Posts: 2
Joined: Mon Nov 23, 2009 8:53 pm

SAM7-P256 boot problem

Tue Nov 24, 2009 1:00 pm

Hi, I recently purchased a SAM7-P256 devboard from Olimex. When I plugged the device in it refused to accept any address given to it by the kernel. So I decided to put it into the SAM-BA boot mode thing with the following procedure:
1. Power down the SAM7S-EK
2. Close the Jumper JP5 named TST
3. Power up the SAM7S-EK
4. Wait 10s
5. Power down the SAM7S-EK
6. Remove the Jumper JP5 named TST
7. Power up the SAM7S-EK

However, when I plug it in now, there isn't even an acknowledgement that a device is plugged in. It's like there is nothing there at all. The power light on the board still comes on, but thats it.

Any ideas?

Thanks
Daine.

Return to “SAM-BA”

Who is online

Users browsing this forum: No registered users and 1 guest