Page 1 of 1

sam-ba: Which address to find ChipID

Posted: Thu Mar 19, 2015 6:45 pm
by rungholt
Hey, we're using sam-ba.dll (v.2.11) to bring AT91SAM9263-EK mainboard software with our own win application to the device. That worked until now. But now we want to use sam-ba.dll (v.2.15). And there are a lot of interface changes. My problem is, which chip id address I have to use to read out the ChipID?
Any ideas?

Re: sam-ba: Which address to find ChipID

Posted: Fri Mar 20, 2015 12:16 pm
by rungholt
My fault. Of course the ChipID address is the same but the interface to read it out changes the datatype from uint to int. I only had to convert the uint address to an int address, then it worked.