I just start yesterday to learn how to modify TCL scripts behind SAM-BA. I have a custom board with a Micron MCP memory (NandFlash and SDRAM). Both use 16-bits wide BUS at 133 MHz. What I need to do in the NandFlash.tcl and the SDRAM.tcl files ?
I already remove AT91C_SMC_DBW_WIDTH_EIGTH_BITS in the NandFlash.tcl file but I don't know if it is enough.
I need to validate the hardware. I saw in other thread (post) that I need to configure (initialize) SDRAM before asking
the manufacturer ID of the Flash.
Microchip in-system programming solution: SAM-BA
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests