fatal no valid processor ID found

Microchip in-system programming solution: SAM-BA

Moderators: nferre, fab

at917512
Posts: 3
Joined: Fri Feb 06, 2009 6:01 pm

fatal no valid processor ID found

Fri Feb 06, 2009 6:20 pm

Hi all,
I'm a newbie in Atmel products and need your help.
I just receive my AT91SAM9G20-EK and try to use SAM-BA v2.8.
When powering the board, the leds are flashing normally.
I connected the 'serial debug port' of the board to the serial COM1 of my PC, with the cable provided, select the connection : COM1 and select your board : AT91SAM9G20-EK, then press Connect.
After 3 to 4 seconds the answer is 'no valid processor ID found'.
When I launch the HyperTerminal program, I see the message from the board at boot time 'rom boot, getting started project 1.4...'
Can you help me please ?
Regards
Carylee
Posts: 1
Joined: Thu Feb 12, 2009 4:06 am

Re: fatal no valid processor ID found

Sat Feb 14, 2009 9:16 am

I think you must load boot code to your board first. Then SAM-BA can catch the board.

Please refer to
http://www.linux4sam.org/twiki/bin/view ... ies_matrix

Return to “SAM-BA”

Who is online

Users browsing this forum: No registered users and 2 guests