I'm trying to use the AT91SAM3S TWI interface in master mode. I am able to get the TWI to send a start condition, device address, and data... but am not able to get a repeated start condition sent (restart).
This is what I'd like to do with the TWI:
1. Start condition
2. Device Address + W
3. Send 'n' data bytes
4. Repeated Start Condition
5. Device Address + R
6. Read 'm' data bytes
7. Stop condition
Is this possible? I do not see it mentioned in the datasheet.
Discussion around product based on ARM Cortex M3 core.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests