We're using a custom board based off of the AT91RM9200-DK. I was able to get 2.4 to run properly, but there seem to be a few differences with 2.6. Are there any tutorials on setting up the system to run an 802.11 card? Can anyone offer some help?
Right now I have pcmciautils running and I can see the card using pccardctl, but it isn't binding to a driver. If I get it to bind to a driver, should it be configured as ETH1?
This forum is for users of Microchip MPUs and who are interested in using Linux OS.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests