I am working on an I2S audio driver for Linux 184.108.40.206 running on a KwikByte KB9202 board attached to a WM8731_EV2 board.
I have followed the Atmel SSC to I2S Application Note to set up the SSC, and have allocated DMA memory using dma_alloc_coherent() to obtain physical memory addresses for the PDC pointers.
For some reason, I am finding that I am completely unable to write to the PDC pointer (e.g., RPR) or counter registers (e.g., RCR). They are set to 0 when the SSC is reset, and do not change at all when I write non-zero values to them.
I can write to the SSC registers just fine. I can also set the TXTEN and RXTEN bits in the PTCR, and the same bits get set in the PTSR. But I cannot change the values in the pointer or counter registers.
If I enable the ENDRX, ENDTX, RXBUFF and TXBUFE interrupts, the interrupt fires immediately as there are zero values in the counters.
I have other devices (USART and SPI) using a PDC running on this board, and there is no problem writing to their pointer and counter registers.
I looked at all PDC coding examples that I can find and I can't see what I am missing.
Has anyone seen this before? Or can anyone think of a reason why this is happening?
This forum is for users of Microchip MPUs and who are interested in using Linux OS.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 2 guests