I'm testing the Interrupt Service Thread (IST) Latency times
on a AT91SAM9263 with Windows CE 6.0 and free Atmel BSP.
I'm using GPIO output to test the delay between the ISR and IST:
most of the times the delay is less than 100us but sometimes
I can see latency times up to 20ms!
So that if I have interrupt frequency higher than 50Hz
the interrupt event is lost.
Note: I'm usign maximum priority for IST (priority = 0).
It seemes strange but this problems happens only in the
Release build of the AT91SAM9263EK_DEMO project.
The ISR works correctly but the interrupt event to the IST is delayed.
Do you have any idea of which is the problem?
Is it possible that a thread is blocking this high priority interrupt event?
Thank you for your answer.
This forum is for users of Atmel's SAM Series and who are interested in using WinCE OS.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests