Hello All --
I have a working product based on the G45 EK with some customization (minor in general). I am trying to enable TFAT on my NAND flash memory and am not sure how to verify that it is enabled and formatted properly.
I have followed the instructions mentioned here:
I also see the code there to test if it is enabled properly... but where in my OS design do I put that code? I have access to my DBG USART to see retail msgs if I can find out where to put this code...
I scrubbed my nandflash and programmed the new firstboot, eboot, and nk into the device and booted up into the shell.
I have a display and shell with the storage manager, so I can check the properties of that (and the partition listed) but only see "Flags" listed there as 0x10.
Thanks for any help you can provide!
This forum is for users of Atmel's SAM Series and who are interested in using WinCE OS.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests