I have configured my kit to boot the WinCE Demo from a Flash Disk throught SAM-BA 2.8 and hyper terminal.
after that, i reset the kit, WinCE run but the hyper terminal display :
PHY ID : 25278624
PHY_GetConfiguration : autoneg not complete
PHY_WaitForAutonegociationComplete Autoneg not complete
on the kit, i get a white screen and it displays this message :
press and briefly stylus on the center of repeat as the target movesaround the screen
please, if you have any idea about this problem, tel me
This forum is for users of Atmel's SAM Series and who are interested in using WinCE OS.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest