cant load image from Platform Builder to AT9261EK

This forum is for users of Atmel's SAM Series and who are interested in using WinCE OS.

Moderator: nferre

iakovlev
Posts: 9
Joined: Thu Oct 23, 2008 7:47 pm

cant load image from Platform Builder to AT9261EK

Wed Nov 19, 2008 6:08 pm

Hello! I made a run-time image in Platform Builder 5.0, loaded Boot-loader into a board, I receive the following from COM-port
*** Initialization of the DM9000 Ethernet controler ****
Waiting for Link by the PHY
Auto-negociate in progress
DM9000 Init Mac address is provided : 0x202 0x403 0x605
INFO: DM9000 Ethernet controller initialized.
INFO: Using device name: 'SAM9261_1286'
INFO: MAC address: 2-2-3-4-5-6
+EbootSendBootmeAndWaitForTftp
Sent BOOTME to 255.255.255.255

I can see my board in list of Active Devices, but when I make 'Attach Device' the message 'Waiting for BOOTME from SAM9261_1286' is appeared.
Where can be the problem? please help
Adeneo
Contact:
Location: France - USA
Posts: 183
Joined: Fri May 14, 2004 9:58 am

Re: cant load image from Platform Builder to AT9261EK

Thu Nov 20, 2008 9:26 am

Hello,

According to what you said you have connected your platform to your PC correctly because you are receiving the broadcast BOOTME trame but the download can't start.

You Mac address seems to be right but the problem can come from your subnet mask or the IP address of the platform.
Are you using DHCP or Static IP?

What I'd advise is to:
1) Verify in the bootloader menu, that the platform has the same subnet mask as you PC
2) Use DHCP if possible
3) If you use Static IP, use a cross over cable and choose the IP address according to your subnet mask.

Best Regards,
Adeneo Support team
iakovlev
Posts: 9
Joined: Thu Oct 23, 2008 7:47 pm

Re: cant load image from Platform Builder to AT9261EK

Thu Nov 20, 2008 6:43 pm

great, thanks! Problem was in my PC settings. Now image is loading!

Return to “WinCE”

Who is online

Users browsing this forum: No registered users and 4 guests